Window AC / August 26, 2018 / Denise Brisette
These extenders will fill the space between the unit and the edges of to keep air from leaking out. Youre now ready to open the window from the bottom pain and have your helper raise the A/C into position. Rest the A/C on the window sill and slide the extensions out to fill any gaps. Check the instructions provided with your A/C for the what the correct placement is for your specific appliance. Most air conditioning units should tilt outward to drain any condensation that may accumulate on it. Finally you will fasten the brackets and lower the window pain back to the top of your machine. Sometimes it is wise to fasten the upper window pane in place to avoid movement of your A/C.
The ductwork for the distribution of the air is also all ready in place. The ductwork may need some modification to make it work well for air conditioning but the major part of it should be adequate. To use the existing furnace and ductwork a coil will need to be installed at the furnace. An outdoor condenser unit will be installed outside and copper tubing will be used to connect the coil to the outdoor unit. Some electrical wiring will need to be done to power the outdoor unit. Low voltage wiring will be needed to hook the thermostat the furnace and the outdoor unit together so that they can talk to each other. Basically the thermostat will just tell the furnace to run the blower on high speed and the outdoor condenser to start up.
Have everything ready and laid out before you have unpacked. Have the screen removed from the window. Remember that these only work for windows that can be pulled up. Ones that crank out will not open wide enough nor will they have anything to hold the air conditioner steady. Open up the window as wide as it can go to give yourself a little extra room to work. It is helpful if you have someone there to push down the top sash when the time comes. Make sure the air conditioner is facing the right way. The front which should be inside the room should have the dials and the cord to plug into the wall.