Window AC / September 17, 2018 / Francoise Salmons.
If there is no central hot air heating then the installation of central air conditioning can be much more difficult. Many homes that do not have hot air heat also do not have the room to install ductwork. This would eliminate this possibility. If you are in this category you should get a professional to look at your situation to see if central air conditioning can be done. If it is the room available is to enough to do a good job and get large enough ductwork installed then do not force the issue and go another option. Ductless split type air conditioning may be your best option.
The answer is It depends on the wall thickness. Sleeve specifications for some window air conditioner manufacturers include the maximum wall thickness before it will cover part of the louvers. For example Amanas 18000 BTU models have a max of 8.5 inches. If the wall thickness is at or below that these models can be used in as a wall air conditioner without adversely affecting function. So whats the problem if the wall covers a little of the louvers? Two things: 1) restriction of air movement and therefore reduced efficiency and 2) these units pull air in very powerfully. Cut wall edges could become loose allowing material to be sucked into the unit and potentially causing damage.
Slowly lessen your grip on it. If the conditioner wobbles the sash is not down tightly enough. After it is secured put in the foam provided around all cracks. You may have to use extra strips of paper towel to really make it tight. This will keep bugs from entering. Plug it in and turn it on. Looking for a GE Window Air Conditioner can be tough as youll soon see there are many General Electric products on the market. GE builds room ac units to accommodate the needs of every consumer whether you need to cool a small room or an entire home.
The back the part that hangs outside should have the vents where water will drip out. Carefully place it on the window sill facing the right way. There should be ridges around the perimeter of the air conditioner to show you where it should line up with the window. Once you have this lined up slide open the side panels. These are designed to fill up the rest of the window that the device does not fill. Slide them as tightly over as you can. Have the top sash of the window lowered carefully and slowly down until it comes into firm contact with the top of the conditioner. The frame should be very tight against it to brace it and keep it from falling.