Window AC / September 18, 2018 / Jacqueline Bizier.
Slowly lessen your grip on it. If the conditioner wobbles the sash is not down tightly enough. After it is secured put in the foam provided around all cracks. You may have to use extra strips of paper towel to really make it tight. This will keep bugs from entering. Plug it in and turn it on. Looking for a GE Window Air Conditioner can be tough as youll soon see there are many General Electric products on the market. GE builds room ac units to accommodate the needs of every consumer whether you need to cool a small room or an entire home.
The back the part that hangs outside should have the vents where water will drip out. Carefully place it on the window sill facing the right way. There should be ridges around the perimeter of the air conditioner to show you where it should line up with the window. Once you have this lined up slide open the side panels. These are designed to fill up the rest of the window that the device does not fill. Slide them as tightly over as you can. Have the top sash of the window lowered carefully and slowly down until it comes into firm contact with the top of the conditioner. The frame should be very tight against it to brace it and keep it from falling.
A window air conditioner in my opinion is a last resort for air conditioning your house or building. There are many down sides to window air conditioning units. There are two good things that window air conditioners have going for them. They are very inexpensive when it comes to cost per BTU of cooling. They also install very quickly and easily. That is where the good part of them ends. Window air conditioners are security risks. If a thief wants to get into your house the thin sheet metal box that holds the unit in the window can easily be pulled apart to get in through the window.
The ductwork for the distribution of the air is also all ready in place. The ductwork may need some modification to make it work well for air conditioning but the major part of it should be adequate. To use the existing furnace and ductwork a coil will need to be installed at the furnace. An outdoor condenser unit will be installed outside and copper tubing will be used to connect the coil to the outdoor unit. Some electrical wiring will need to be done to power the outdoor unit. Low voltage wiring will be needed to hook the thermostat the furnace and the outdoor unit together so that they can talk to each other. Basically the thermostat will just tell the furnace to run the blower on high speed and the outdoor condenser to start up.