Window AC / September 20, 2018 / Marphisa Babin
Have everything ready and laid out before you have unpacked. Have the screen removed from the window. Remember that these only work for windows that can be pulled up. Ones that crank out will not open wide enough nor will they have anything to hold the air conditioner steady. Open up the window as wide as it can go to give yourself a little extra room to work. It is helpful if you have someone there to push down the top sash when the time comes. Make sure the air conditioner is facing the right way. The front which should be inside the room should have the dials and the cord to plug into the wall.
If you already have a window air conditioning unit and you have noticed recently that it seems to be louder there are few steps you should take. Check to see if the unit is vibrating on the windowsill. It may need to be re-tightened on its shelf. The side panels might also be loose. Inspect those to see if they need tightening. If the unit seems to be vibrating more than normal consider sliding a piece of wood under the unit to secure it. For more tips about finding the best air conditioner check out these helpful guides: Your Guide to Finding Everstar Portable Air Conditioner Parts and Your Guide to Windowless AC Units.
The ductwork for the distribution of the air is also all ready in place. The ductwork may need some modification to make it work well for air conditioning but the major part of it should be adequate. To use the existing furnace and ductwork a coil will need to be installed at the furnace. An outdoor condenser unit will be installed outside and copper tubing will be used to connect the coil to the outdoor unit. Some electrical wiring will need to be done to power the outdoor unit. Low voltage wiring will be needed to hook the thermostat the furnace and the outdoor unit together so that they can talk to each other. Basically the thermostat will just tell the furnace to run the blower on high speed and the outdoor condenser to start up.