Window AC / August 26, 2018 / Denise Brisette
If there is no central hot air heating then the installation of central air conditioning can be much more difficult. Many homes that do not have hot air heat also do not have the room to install ductwork. This would eliminate this possibility. If you are in this category you should get a professional to look at your situation to see if central air conditioning can be done. If it is the room available is to enough to do a good job and get large enough ductwork installed then do not force the issue and go another option. Ductless split type air conditioning may be your best option.
The answer is It depends on the wall thickness. Sleeve specifications for some window air conditioner manufacturers include the maximum wall thickness before it will cover part of the louvers. For example Amanas 18000 BTU models have a max of 8.5 inches. If the wall thickness is at or below that these models can be used in as a wall air conditioner without adversely affecting function. So whats the problem if the wall covers a little of the louvers? Two things: 1) restriction of air movement and therefore reduced efficiency and 2) these units pull air in very powerfully. Cut wall edges could become loose allowing material to be sucked into the unit and potentially causing damage.
One sees a similar box for a wall air conditioner. Naturally people assume they are the same. But they arent and this article will explain why. The two types share some characteristics. Both span the dividing line from inside to outside allowing all components to be housed in a single box. Therefore both utilize both inside and outside air to perform. Both are designed to condition a single room. But there are differences. Windows are thin and the sleeve for a window unit is designed to take advantage of this. It sits on the window sill with the window closed onto the case to seal the top.