Window AC / September 7, 2018 / Aubrette Dumoulin
The ductwork for the distribution of the air is also all ready in place. The ductwork may need some modification to make it work well for air conditioning but the major part of it should be adequate. To use the existing furnace and ductwork a coil will need to be installed at the furnace. An outdoor condenser unit will be installed outside and copper tubing will be used to connect the coil to the outdoor unit. Some electrical wiring will need to be done to power the outdoor unit. Low voltage wiring will be needed to hook the thermostat the furnace and the outdoor unit together so that they can talk to each other. Basically the thermostat will just tell the furnace to run the blower on high speed and the outdoor condenser to start up.
One sees a similar box for a wall air conditioner. Naturally people assume they are the same. But they arent and this article will explain why. The two types share some characteristics. Both span the dividing line from inside to outside allowing all components to be housed in a single box. Therefore both utilize both inside and outside air to perform. Both are designed to condition a single room. But there are differences. Windows are thin and the sleeve for a window unit is designed to take advantage of this. It sits on the window sill with the window closed onto the case to seal the top.
If there is no central hot air heating then the installation of central air conditioning can be much more difficult. Many homes that do not have hot air heat also do not have the room to install ductwork. This would eliminate this possibility. If you are in this category you should get a professional to look at your situation to see if central air conditioning can be done. If it is the room available is to enough to do a good job and get large enough ductwork installed then do not force the issue and go another option. Ductless split type air conditioning may be your best option.