Window AC / September 19, 2018 / Lundy Brochu.
Depending on the size and level of insulation of your home one window air conditioner is typically enough to cool one or two rooms but larger units may even be able to cool an entire 2-3 bedroom apartment. Using multiple cooling units in a home will allow each person in the family to keep their room at the temperature they desire. Installing a cooling unit will take anywhere from ten to forty minutes. Choosing the Right Air Conditioner
I have seen many units that are not even screwed fast. If the window air conditioner is just there balancing in the window frame it becomes very inviting for a unexpected guest. The window air conditioner is also very inefficient. These units use more power per BTU of cooling than any other type of air conditioner. If you are a light sleeper than chances are you will not want one of these window shakers. Window air conditioners are one of the loudest forms of air conditioning. The blower for these units is very loud when running. Then add the noise of the compressor and you have enough decibels to keep many people wide awake all night long.
The ductwork for the distribution of the air is also all ready in place. The ductwork may need some modification to make it work well for air conditioning but the major part of it should be adequate. To use the existing furnace and ductwork a coil will need to be installed at the furnace. An outdoor condenser unit will be installed outside and copper tubing will be used to connect the coil to the outdoor unit. Some electrical wiring will need to be done to power the outdoor unit. Low voltage wiring will be needed to hook the thermostat the furnace and the outdoor unit together so that they can talk to each other. Basically the thermostat will just tell the furnace to run the blower on high speed and the outdoor condenser to start up.
The back the part that hangs outside should have the vents where water will drip out. Carefully place it on the window sill facing the right way. There should be ridges around the perimeter of the air conditioner to show you where it should line up with the window. Once you have this lined up slide open the side panels. These are designed to fill up the rest of the window that the device does not fill. Slide them as tightly over as you can. Have the top sash of the window lowered carefully and slowly down until it comes into firm contact with the top of the conditioner. The frame should be very tight against it to brace it and keep it from falling.