Window AC / September 23, 2018 / DixieLemieux
The back the part that hangs outside should have the vents where water will drip out. Carefully place it on the window sill facing the right way. There should be ridges around the perimeter of the air conditioner to show you where it should line up with the window. Once you have this lined up slide open the side panels. These are designed to fill up the rest of the window that the device does not fill. Slide them as tightly over as you can. Have the top sash of the window lowered carefully and slowly down until it comes into firm contact with the top of the conditioner. The frame should be very tight against it to brace it and keep it from falling.
Side panels fill the gaps on the sides. These are also very thin so most of the sleeve is uncovered and outside. This allows for placement of ventilation louvers on the sides and top allowing free movement of air. This is the primary difference between the two types. The wide availability of louver space allows the unit to move a lot of air and this means window units can be quite powerful up to 3 tons or 36000 BTU. So window A/Cs can be effective for very large rooms. In contrast a wall air conditioner sleeve is designed for a hole through the wall. Walls vary substantially in thickness.
One sees a similar box for a wall air conditioner. Naturally people assume they are the same. But they arent and this article will explain why. The two types share some characteristics. Both span the dividing line from inside to outside allowing all components to be housed in a single box. Therefore both utilize both inside and outside air to perform. Both are designed to condition a single room. But there are differences. Windows are thin and the sleeve for a window unit is designed to take advantage of this. It sits on the window sill with the window closed onto the case to seal the top.