Window AC / September 20, 2018 / Marphisa Babin
Another huge improvement in window air conditioners is in their appearance. Older models did not blend in very well with their surroundings. They were usually some shade of brown and looked like there was a box in your window. Window air conditioners today are much less obtrusive and look less like boxes. Corners are rounded and colors are much lighter. This gives them a much sleeker look. As with most things once they have been around for awhile cost become more reasonable and less of an obstacle. A window air conditioner can be purchase for less than two hundred dollars and often not much more than one hundred dollars. Of course this is for smaller units. Costs go up as the cooling capacity of the unit increases.
The ductwork for the distribution of the air is also all ready in place. The ductwork may need some modification to make it work well for air conditioning but the major part of it should be adequate. To use the existing furnace and ductwork a coil will need to be installed at the furnace. An outdoor condenser unit will be installed outside and copper tubing will be used to connect the coil to the outdoor unit. Some electrical wiring will need to be done to power the outdoor unit. Low voltage wiring will be needed to hook the thermostat the furnace and the outdoor unit together so that they can talk to each other. Basically the thermostat will just tell the furnace to run the blower on high speed and the outdoor condenser to start up.
When purchasing a window air conditioner it is very important to purchase one with the proper cooling capacity. An air conditioner that is not properly sized will not work as efficiently as one that is sized properly. This is one of the most common mistakes made when selecting air conditioners. Use an air conditioner size calculator to select the proper sized unit for the room you want to cool. Undersized air conditioners will run continuously and not cool the space adequately and an oversized unit will cycle on and off too often. This increases equipment wear and can actually cause fuses to fail.