Window AC / September 12, 2018 / Lundy Brochu.
Have everything ready and laid out before you have unpacked. Have the screen removed from the window. Remember that these only work for windows that can be pulled up. Ones that crank out will not open wide enough nor will they have anything to hold the air conditioner steady. Open up the window as wide as it can go to give yourself a little extra room to work. It is helpful if you have someone there to push down the top sash when the time comes. Make sure the air conditioner is facing the right way. The front which should be inside the room should have the dials and the cord to plug into the wall.
The back the part that hangs outside should have the vents where water will drip out. Carefully place it on the window sill facing the right way. There should be ridges around the perimeter of the air conditioner to show you where it should line up with the window. Once you have this lined up slide open the side panels. These are designed to fill up the rest of the window that the device does not fill. Slide them as tightly over as you can. Have the top sash of the window lowered carefully and slowly down until it comes into firm contact with the top of the conditioner. The frame should be very tight against it to brace it and keep it from falling.
They are also easy to install unlike split air systems and central ac. Installing a window unit is an easy DIY job that can be tackled in an hour or so. Also because they are installed in a semi-permanent fashion you just set it and forget it. Unlike portable ac units which are often wheeled around from room to room a window unit is designed to stay put. In spite of all of these benefits however window units have one major drawback: the noise. These units are loud and different models can range from being moderately annoying to downright deafening.
One sees a similar box for a wall air conditioner. Naturally people assume they are the same. But they arent and this article will explain why. The two types share some characteristics. Both span the dividing line from inside to outside allowing all components to be housed in a single box. Therefore both utilize both inside and outside air to perform. Both are designed to condition a single room. But there are differences. Windows are thin and the sleeve for a window unit is designed to take advantage of this. It sits on the window sill with the window closed onto the case to seal the top.