Window AC / August 26, 2018 / Denise Brisette
Many people do not know how to set up a window air conditioner and therefore just allow their homes or offices to remain sweltering during the summer. Window air conditioners are great because they are the least invasive air conditioning systems to install and can very easily be turned off or removed as is needed. They are easy to put in and should come with descriptive directions and charts. However not all directions give little tips and tricks. The first thing you should do is make sure to install it during the day. Daylight will make it easier to see what you are doing so it does not fall out of the window and it will also keep bugs from entering while the window is open.
The ductwork for the distribution of the air is also all ready in place. The ductwork may need some modification to make it work well for air conditioning but the major part of it should be adequate. To use the existing furnace and ductwork a coil will need to be installed at the furnace. An outdoor condenser unit will be installed outside and copper tubing will be used to connect the coil to the outdoor unit. Some electrical wiring will need to be done to power the outdoor unit. Low voltage wiring will be needed to hook the thermostat the furnace and the outdoor unit together so that they can talk to each other. Basically the thermostat will just tell the furnace to run the blower on high speed and the outdoor condenser to start up.
The answer is It depends on the wall thickness. Sleeve specifications for some window air conditioner manufacturers include the maximum wall thickness before it will cover part of the louvers. For example Amanas 18000 BTU models have a max of 8.5 inches. If the wall thickness is at or below that these models can be used in as a wall air conditioner without adversely affecting function. So whats the problem if the wall covers a little of the louvers? Two things: 1) restriction of air movement and therefore reduced efficiency and 2) these units pull air in very powerfully. Cut wall edges could become loose allowing material to be sucked into the unit and potentially causing damage.