Window AC / August 24, 2018 / Aubrette Dumoulin
If the room is shaded then you can decrease the BTU rating you calculated with the climate control unit calculator by 10 percent however if you wish to cool a kitchen youll need to raise the rating by 4000 BTUs. When the room you are cooling is used by two or more people add six hundred BTUs per person to the rating necessary to cool the room. Before you buy the first air conditioner that fits the BTU rating necessary to cool your room make sure you have a window that will be suitable for the unit. Measure windows in the room (make sure not to block fire escapes) and make sure to buy a window air conditioner that will fit into the opening.
One sees a similar box for a wall air conditioner. Naturally people assume they are the same. But they arent and this article will explain why. The two types share some characteristics. Both span the dividing line from inside to outside allowing all components to be housed in a single box. Therefore both utilize both inside and outside air to perform. Both are designed to condition a single room. But there are differences. Windows are thin and the sleeve for a window unit is designed to take advantage of this. It sits on the window sill with the window closed onto the case to seal the top.
The ductwork for the distribution of the air is also all ready in place. The ductwork may need some modification to make it work well for air conditioning but the major part of it should be adequate. To use the existing furnace and ductwork a coil will need to be installed at the furnace. An outdoor condenser unit will be installed outside and copper tubing will be used to connect the coil to the outdoor unit. Some electrical wiring will need to be done to power the outdoor unit. Low voltage wiring will be needed to hook the thermostat the furnace and the outdoor unit together so that they can talk to each other. Basically the thermostat will just tell the furnace to run the blower on high speed and the outdoor condenser to start up.