Window AC / September 15, 2018 / Babette Arsenault
If the room is shaded then you can decrease the BTU rating you calculated with the climate control unit calculator by 10 percent however if you wish to cool a kitchen youll need to raise the rating by 4000 BTUs. When the room you are cooling is used by two or more people add six hundred BTUs per person to the rating necessary to cool the room. Before you buy the first air conditioner that fits the BTU rating necessary to cool your room make sure you have a window that will be suitable for the unit. Measure windows in the room (make sure not to block fire escapes) and make sure to buy a window air conditioner that will fit into the opening.
If there is no central hot air heating then the installation of central air conditioning can be much more difficult. Many homes that do not have hot air heat also do not have the room to install ductwork. This would eliminate this possibility. If you are in this category you should get a professional to look at your situation to see if central air conditioning can be done. If it is the room available is to enough to do a good job and get large enough ductwork installed then do not force the issue and go another option. Ductless split type air conditioning may be your best option.
The ductwork for the distribution of the air is also all ready in place. The ductwork may need some modification to make it work well for air conditioning but the major part of it should be adequate. To use the existing furnace and ductwork a coil will need to be installed at the furnace. An outdoor condenser unit will be installed outside and copper tubing will be used to connect the coil to the outdoor unit. Some electrical wiring will need to be done to power the outdoor unit. Low voltage wiring will be needed to hook the thermostat the furnace and the outdoor unit together so that they can talk to each other. Basically the thermostat will just tell the furnace to run the blower on high speed and the outdoor condenser to start up.