Window AC / September 18, 2018 / Jacqueline Bizier
The main aspect in the choice of window air conditioner is its cool air performance. You can approximate the required power at the rate of 1 kW per 10 sq.m. with a ceiling height of 2.8 - 3 meters; for household models the characteristic is: from 1.5 - 2 to 6.5 - 8.5 kW. If there is a large glass area in the room windows face south or there are other additional heat inputs one should better buy a model with a power reserve of 15-20%. Another important factor in choosing window air conditioner is room functionality. For example air conditioner installed in the kitchen must be of high performance to provide optimal heat control. Air conditioning unit for bedrooms should have low noise characteristics.
The ductwork for the distribution of the air is also all ready in place. The ductwork may need some modification to make it work well for air conditioning but the major part of it should be adequate. To use the existing furnace and ductwork a coil will need to be installed at the furnace. An outdoor condenser unit will be installed outside and copper tubing will be used to connect the coil to the outdoor unit. Some electrical wiring will need to be done to power the outdoor unit. Low voltage wiring will be needed to hook the thermostat the furnace and the outdoor unit together so that they can talk to each other. Basically the thermostat will just tell the furnace to run the blower on high speed and the outdoor condenser to start up.
The back the part that hangs outside should have the vents where water will drip out. Carefully place it on the window sill facing the right way. There should be ridges around the perimeter of the air conditioner to show you where it should line up with the window. Once you have this lined up slide open the side panels. These are designed to fill up the rest of the window that the device does not fill. Slide them as tightly over as you can. Have the top sash of the window lowered carefully and slowly down until it comes into firm contact with the top of the conditioner. The frame should be very tight against it to brace it and keep it from falling.