Window AC / September 1, 2018 / Babette Arsenault
These extenders will fill the space between the unit and the edges of to keep air from leaking out. Youre now ready to open the window from the bottom pain and have your helper raise the A/C into position. Rest the A/C on the window sill and slide the extensions out to fill any gaps. Check the instructions provided with your A/C for the what the correct placement is for your specific appliance. Most air conditioning units should tilt outward to drain any condensation that may accumulate on it. Finally you will fasten the brackets and lower the window pain back to the top of your machine. Sometimes it is wise to fasten the upper window pane in place to avoid movement of your A/C.
The ductwork for the distribution of the air is also all ready in place. The ductwork may need some modification to make it work well for air conditioning but the major part of it should be adequate. To use the existing furnace and ductwork a coil will need to be installed at the furnace. An outdoor condenser unit will be installed outside and copper tubing will be used to connect the coil to the outdoor unit. Some electrical wiring will need to be done to power the outdoor unit. Low voltage wiring will be needed to hook the thermostat the furnace and the outdoor unit together so that they can talk to each other. Basically the thermostat will just tell the furnace to run the blower on high speed and the outdoor condenser to start up.
One sees a similar box for a wall air conditioner. Naturally people assume they are the same. But they arent and this article will explain why. The two types share some characteristics. Both span the dividing line from inside to outside allowing all components to be housed in a single box. Therefore both utilize both inside and outside air to perform. Both are designed to condition a single room. But there are differences. Windows are thin and the sleeve for a window unit is designed to take advantage of this. It sits on the window sill with the window closed onto the case to seal the top.