Window AC / September 20, 2018 / Marphisa Babin
If there is no central hot air heating then the installation of central air conditioning can be much more difficult. Many homes that do not have hot air heat also do not have the room to install ductwork. This would eliminate this possibility. If you are in this category you should get a professional to look at your situation to see if central air conditioning can be done. If it is the room available is to enough to do a good job and get large enough ductwork installed then do not force the issue and go another option. Ductless split type air conditioning may be your best option.
The back the part that hangs outside should have the vents where water will drip out. Carefully place it on the window sill facing the right way. There should be ridges around the perimeter of the air conditioner to show you where it should line up with the window. Once you have this lined up slide open the side panels. These are designed to fill up the rest of the window that the device does not fill. Slide them as tightly over as you can. Have the top sash of the window lowered carefully and slowly down until it comes into firm contact with the top of the conditioner. The frame should be very tight against it to brace it and keep it from falling.
Why are window air conditioners so loud? Well the reason is simple: because the entire air conditioner - the compressor the condenser and the fans - are all located in one single unit. By contrast with a split ac and a central air conditioner the compressor and condenser are installed outside of your home. That means that in those units the loudest parts arent in your home. With a window unit however the noisiest parts of the unit are inside your home. This can be a minor annoyance. It may mean that you have to turn up the volume on the tv to hear it. But it can also mean sleepless nights if your window air conditioner in your bedroom is deafening.