Window AC / August 29, 2018 / Lundy Brochu.
The most commonly used air conditioners are window air conditioners. This is due mostly to the fact that they are the cheapest alternative when it comes to cooling our homes. But there are other reasons also. For example they install in a window out of the way. Install it and forget it. These units are also available with electric heat options. Window air conditioners were once so noisy that they were nicknamed window bangers. This term was very accurate and well deserved. However todays window air conditioners are very different from the ones many of us learned to hate.
If there is no central hot air heating then the installation of central air conditioning can be much more difficult. Many homes that do not have hot air heat also do not have the room to install ductwork. This would eliminate this possibility. If you are in this category you should get a professional to look at your situation to see if central air conditioning can be done. If it is the room available is to enough to do a good job and get large enough ductwork installed then do not force the issue and go another option. Ductless split type air conditioning may be your best option.
The back the part that hangs outside should have the vents where water will drip out. Carefully place it on the window sill facing the right way. There should be ridges around the perimeter of the air conditioner to show you where it should line up with the window. Once you have this lined up slide open the side panels. These are designed to fill up the rest of the window that the device does not fill. Slide them as tightly over as you can. Have the top sash of the window lowered carefully and slowly down until it comes into firm contact with the top of the conditioner. The frame should be very tight against it to brace it and keep it from falling.
These extenders will fill the space between the unit and the edges of to keep air from leaking out. Youre now ready to open the window from the bottom pain and have your helper raise the A/C into position. Rest the A/C on the window sill and slide the extensions out to fill any gaps. Check the instructions provided with your A/C for the what the correct placement is for your specific appliance. Most air conditioning units should tilt outward to drain any condensation that may accumulate on it. Finally you will fasten the brackets and lower the window pain back to the top of your machine. Sometimes it is wise to fasten the upper window pane in place to avoid movement of your A/C.