Window AC / September 6, 2018 / Marphisa Babin
Another huge improvement in window air conditioners is in their appearance. Older models did not blend in very well with their surroundings. They were usually some shade of brown and looked like there was a box in your window. Window air conditioners today are much less obtrusive and look less like boxes. Corners are rounded and colors are much lighter. This gives them a much sleeker look. As with most things once they have been around for awhile cost become more reasonable and less of an obstacle. A window air conditioner can be purchase for less than two hundred dollars and often not much more than one hundred dollars. Of course this is for smaller units. Costs go up as the cooling capacity of the unit increases.
The answer is It depends on the wall thickness. Sleeve specifications for some window air conditioner manufacturers include the maximum wall thickness before it will cover part of the louvers. For example Amanas 18000 BTU models have a max of 8.5 inches. If the wall thickness is at or below that these models can be used in as a wall air conditioner without adversely affecting function. So whats the problem if the wall covers a little of the louvers? Two things: 1) restriction of air movement and therefore reduced efficiency and 2) these units pull air in very powerfully. Cut wall edges could become loose allowing material to be sucked into the unit and potentially causing damage.
The back the part that hangs outside should have the vents where water will drip out. Carefully place it on the window sill facing the right way. There should be ridges around the perimeter of the air conditioner to show you where it should line up with the window. Once you have this lined up slide open the side panels. These are designed to fill up the rest of the window that the device does not fill. Slide them as tightly over as you can. Have the top sash of the window lowered carefully and slowly down until it comes into firm contact with the top of the conditioner. The frame should be very tight against it to brace it and keep it from falling.