Window AC / August 11, 2018 / Francoise Salmons.
The back the part that hangs outside should have the vents where water will drip out. Carefully place it on the window sill facing the right way. There should be ridges around the perimeter of the air conditioner to show you where it should line up with the window. Once you have this lined up slide open the side panels. These are designed to fill up the rest of the window that the device does not fill. Slide them as tightly over as you can. Have the top sash of the window lowered carefully and slowly down until it comes into firm contact with the top of the conditioner. The frame should be very tight against it to brace it and keep it from falling.
The most commonly used air conditioners are window air conditioners. This is due mostly to the fact that they are the cheapest alternative when it comes to cooling our homes. But there are other reasons also. For example they install in a window out of the way. Install it and forget it. These units are also available with electric heat options. Window air conditioners were once so noisy that they were nicknamed window bangers. This term was very accurate and well deserved. However todays window air conditioners are very different from the ones many of us learned to hate.
An additional benefit of a properly sized air conditioner is humidity control. While these units are operating moisture condenses on the evaporator coil just like a dehumidifier. Probably the most common problem with window air conditioners is that they sometimes develop rattling noises due to vibration. This is not a serious problem and can be rectified very easily by checking to make sure all screws are tight and check that the unit is mounted correctly in the window and not twisted or stressed. Air Conditioning is something that many people look at installing every year. There are many options when it comes time to make that decision.
One sees a similar box for a wall air conditioner. Naturally people assume they are the same. But they arent and this article will explain why. The two types share some characteristics. Both span the dividing line from inside to outside allowing all components to be housed in a single box. Therefore both utilize both inside and outside air to perform. Both are designed to condition a single room. But there are differences. Windows are thin and the sleeve for a window unit is designed to take advantage of this. It sits on the window sill with the window closed onto the case to seal the top.