Window AC / September 14, 2018 / Aubrette Dumoulin
The back the part that hangs outside should have the vents where water will drip out. Carefully place it on the window sill facing the right way. There should be ridges around the perimeter of the air conditioner to show you where it should line up with the window. Once you have this lined up slide open the side panels. These are designed to fill up the rest of the window that the device does not fill. Slide them as tightly over as you can. Have the top sash of the window lowered carefully and slowly down until it comes into firm contact with the top of the conditioner. The frame should be very tight against it to brace it and keep it from falling.
These extenders will fill the space between the unit and the edges of to keep air from leaking out. Youre now ready to open the window from the bottom pain and have your helper raise the A/C into position. Rest the A/C on the window sill and slide the extensions out to fill any gaps. Check the instructions provided with your A/C for the what the correct placement is for your specific appliance. Most air conditioning units should tilt outward to drain any condensation that may accumulate on it. Finally you will fasten the brackets and lower the window pain back to the top of your machine. Sometimes it is wise to fasten the upper window pane in place to avoid movement of your A/C.
The ductwork for the distribution of the air is also all ready in place. The ductwork may need some modification to make it work well for air conditioning but the major part of it should be adequate. To use the existing furnace and ductwork a coil will need to be installed at the furnace. An outdoor condenser unit will be installed outside and copper tubing will be used to connect the coil to the outdoor unit. Some electrical wiring will need to be done to power the outdoor unit. Low voltage wiring will be needed to hook the thermostat the furnace and the outdoor unit together so that they can talk to each other. Basically the thermostat will just tell the furnace to run the blower on high speed and the outdoor condenser to start up.